Cherry Curio Cabinet

   Hi everyone, I've been working some cherry wood to make a nice two door curio cabinet. I lost a day during the week due to the freezing rain that came through in the early hours of Tuesday. I operate a combination salter plow unit on Hwy 401 during the winter months. I had to get a little shut eye after a bleary eyed night of salting roads. Power tools and sleep deprivation lead to lose of digits.

Here are some pics of from this week.

Start with ripping up some rough lumber to make the corner posts. Luckily all the wood for this project came from the same tree from Jeff Waite.

Jointed edges and planed to thickness

Cut 45 degree angles on the edges

Glue them up like this and you have the corner posts.

Mark out the mortise holes that will accept the tenons from the horizontal rails.

Cut the holes with a square chiseled mortising bit.

The holes the mortising chisel creates look like these.

I take time to ensure that I can get all the horizontal members that you see on any given side of the cabinet from the same board so the color and wood grain work together. I also do the same for vertical parts. You won't get that kind of attention with factory built furniture.

Trying to match some grain for the door rails (top and bottom) to give some visual interest to the doors.

Lots of rails with the tenons ready to be fitted. I use machines to rough out the tenons then fit the tenons to the mortises using hand tools.

It's finicky work but makes for good strong joints.

Here is an end assembly coming together.

 

Things are fitting together nicely, still lots left to do.

  Hopefully next week I will post again and have some of the detailing to show you.
Until then I'll be in the shop.

Thanks, Ken